Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Sep 08, 2010 7:16 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: selecting image
PostPosted: Mon Jul 26, 2010 3:19 am 
Offline

Joined: Mon Jul 26, 2010 3:11 am
Posts: 3
ok how do you select JUST part of a image? and can you tell me in steps? I am new to the software and could not find much of a instruction manual.
Michelle ;)


Top
 Profile  
 
 Post subject: Re: selecting image
PostPosted: Thu Jul 29, 2010 6:09 am 
Offline

Joined: Sun Jan 11, 2009 7:16 am
Posts: 2784
Location: Michigan, SCAL1; SCAL2; XP, Windows7 64 bit
How you select part of an image depends on what you have.

If there are just pieces that are placed on the virtual mat you can click on the pieces (hold down shift key to select additional pieces). You can also draw a selection box around the pieces, but it will select all pieces that are even partially inside the selection.

If the parts are grouped, you will need to use Object/Ungroup first.

If the parts are part of a single object use Object/Break apart first.

_________________
My blog


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Groupss